湖南ABB代理商供應 伺服電機 3HAC029924-003三軸電機

伺服電機維修故障范圍：

維修故障：

•   磁鐵爆鋼、磁鐵脫落、卡死轉不動、

•   編碼器磨損、碼盤/玻璃盤磨損破裂、

•   電機發熱發燙、電機進水、

•   電機運轉異常、

•   高速運轉響聲、噪音大，

•   剎車失靈、剎車片磨損、

•   低速正常高速偏差、高速正常低速偏差、

•   啟動報警、啟動跳閘、

•   過載、過壓、過流、

•   不能啟動、啟動無力、運行抖動、

•     失磁、跑位、走偏差、

•   輸出不平衡、

•   編碼器報警、編碼器損壞、

•   位置不準、

•   一通電就報警、一通電就跳閘、

•   驅動器伺服器報警代碼、

•   燒線圈繞組、

•   航空插頭損壞、

•   原點位置不對，編碼器調試/調零位、

•   更換軸承、軸承槽磨損、

•   轉子斷裂，軸斷裂、

•   齒輪槽磨損等
  
  如果你有關于機器人任何配件的維修咨詢，請即時與湖南馳開智能機器人有限公司聯系吧。

Scope of servo motor maintenance faults:
Repair fault:
Magnet explodes, magnet falls off, gets stuck and cannot rotate
Encoder wear, code disc/glass disc wear and tear
Motor heating and scalding, motor water ingress
Abnormal motor operation
High speed operation with loud noise,
Brake failure, brake pad wear
Low speed normal high speed deviation, high speed normal low speed deviation
Start alarm, start tripping
Overload, overvoltage, overcurrent
Unable to start, weak start, shaking operation
Loss of excitation, displacement, deviation
Output imbalance
Encoder alarm, encoder damage
Inaccurate position
Alarm upon power on, trip upon power on
Drive server alarm codes
Burn coil winding
Damaged aviation plug
The origin position is incorrect, encoder debugging/zero adjustment
Replace bearings, wear bearing grooves
The rotor is broken, the shaft is broken
Gear groove wear, etc
If you have any maintenance inquiries about any parts of the robot, please contact Hunan Chikai Intelligent Robot Co., Ltd. immediately.