用滴管將聚合氯化鋁的水溶液慢慢添加到污水中，并使用玻璃棒進行攪拌，觀察污水的絮凝效果，如果出現礬花就表示聚合氯化鋁的絮凝效果較好，然后將不同的量的聚合氯化鋁水溶液添加到污水的樣品中，攪拌靜置一段時間后觀察看哪個污水樣品更加干凈清澈。在使用聚合氯化鋁的過程中，有時候需要添加一些其他的助凝劑如聚丙烯酰胺等，這樣會加快污水的絮凝和沉淀達到更加好的處理效果。ties. The flocculation is deteriorated gradually with the addition of hydrolysis degree. Anionic polyacrylamide as a comprehensive result: the hydrolysis ratio is too large, the cost of adding alkali is higher, the hydrolysis ratio is too small, and the reaction will be insufficient, the coagulation or coagulation of anionic polyacrylamide is poor. Therefore, anionic polyacrylamide is not necessarily hydrolyzed higher, the better, everything will have a limit, the appropriate is Zui excellent Henan Anjiajing Environmental Protection is a professional production of various water treatment agents, committed to the continued use of green and environmentally friendly renewable resources, a lot of investment in scientific research funds, the primary product is polyacrylamide flocs. Coagulation series, polyaluminium chloride series, polyferric sulfate series, alkaline aluminium chloride series and so on are all praised by the national customers. We will continue to produce high-quality products to repay customers for our support of the production and market analysis of polyacrylamide, we can get the following understandings:
1、我國已有10個5000t/a以上的PAM生產廠，其中有5個萬噸級PAM大廠。這典 廠家占全國年產量的56%，生產的集中度正在提高。PAM全行業的總銷售額為62億元。
4、由于一些油田淡水資源的缺乏及降低生產成本、環保等方面的要求，三次采油多采用污水配制聚合物，對耐溫抗鹽聚合物的需求越來越多，有取代高分子聚丙烯酰胺的趨勢，而我國能夠生產抗鹽聚合物的企業只有三四家，總生產能力在6×104t左右，遠遠不能滿足三次采油的需求，因此，抗鹽聚丙烯酰胺具有廣闊的應用前景。
There are 10 PAM factories with a capacity of more than 5000t/a in China, of which there are 5 large PAM factories with a capacity of 10,000 tons. This manufacturer accounts for 56% of the country's annual output, and the concentration of production is increasing. The total sales volume of PAM industry is 6.2 billion yuan.
2. The main uses of PAM are oil field, water treatment and papermaking, and there is still room for increasing the amount of PAM. The second largest market, water treatment, has accounted for one fourth of the total
PAM market and will grow faster than the oilfield market. At present, the paper-making market is relatively concentrated and occupied by four or five PAM factories, some of which have strong specificity. The proportion of cationic polyacrylamide is only 13%. From the future development of water treatment market, the development of cationic polyacrylamide will have a faster growth rate.
3. At present, PAM products occupy an important position in China's energy strategy and water-saving strategy, and are indispensable products. It will play a more active role in the energy crisis in China and the world as well as in the next more serious water resources crisis.
4. Because of the shortage of freshwater resources in some oilfields and the requirement of reducing production cost and environmental protection, sewage is mostly used to prepare polymers for tertiary oil recovery. There is an increasing demand for temperature-resistant and salt-resistant polymers, which tends to replace polymer polyacrylamide in an all-round way. However, only three or four enterprises in China can produce salt-resistant polymers. The total production capacity of salt-resistant polyacrylamide is about 6 *104t, which can not meet the demand of tertiary oil recovery. Therefore, salt-resistant polyacrylamide has broad application prospects.
In addition, the demand for polyacrylamide products will increase considerably in recent years due to the attention paid by our government and relevant enterprises to sewage treatment. Most domestic enterprises plan to build polyacrylamide projects mainly for urban sewage treatment. According to experts'prediction, the annual demand of municipal wastewater treatment in Shanghai alone will reach 1 x104t. It can be expected that the application potential of polyacrylamide products in wastewater treatment will be tremendous.
It can be seen that salt-resistant polyacrylamide products have broad application prospects in tertiary oil recovery and sewage treatment.
