SimpliMet 3000通用熱壓鑲嵌機

SimpliMet 3000通用熱壓鑲嵌機

通用熱壓鑲嵌機存儲和撤銷5種不同的程序，降低復雜性和消除錯誤，提供靈活性來滿足多變的實驗室要求，通過選擇不同尺寸的模具來優化各種各樣的試樣大小。節約鑲嵌介質并提升鑲嵌質量。

該款通用熱壓鑲嵌機適用于具有多種鑲嵌樣需求的實驗室用戶。采用預編程記錄各種鑲嵌方法，可對不同尺寸的鑲嵌樣進行重復制作。

產品優點：

可編程性降低復雜性

適用于有多種鑲嵌樣需求且鑲嵌尺寸不同的實驗室。

存儲和撤銷5種不同的程序，降低復雜性和消除錯誤，提供靈活性來滿足多變的實驗室要求

通過選擇不同尺寸的模具來優化各種各樣的試樣大小。節約鑲嵌介質并提升鑲嵌質量

Operation

Automatic electro-hydraulic

Power Source

85-264VAC, 50/60Hz, 1 phase

Molding Pressure

1200 - 4400psi [80 - 300bar] in 100psi [5bar] increments

Molding Temperature

120 - 360°F [50 - 80°C] in 20°F [10°C] increments

Heating Power

1500Watt @ 115/230VAC

Heating Time

0 - 20 minutes in 10 second increments

Cooling Time

0 - 30 minutes in 10 second increments

Mold Type

Cylindrical, including upper and lower rams and duplex mold spacer

Closure Type

Insluated bayonet with piston indent

Mold Diameters

1in, 1.25in, 1.5in, 2in, 25mm, 30mm, 40mm, 50mm

Touch-pad Controls

On/Off; Heat Time; Cool Time; Molding Temperature; Molding Pressure; Mold Size; Ram Up/Down; Maunal Cool; Cycle Start; Cylinder Open; Unit of Measure; Language and also including Thermoplastic; Load and Save Methods

Units of Measure

Imperial or Metric

Water Flow Rate

0.5gal/min [2?/min] minimum

Water Pressure

45-75psi [3-5bar]

Control Voltage

24VDC

Method Programmability

4 Buehler, Preprogrammed Methods per mold size; 25 User Definable Methods

Preload Pressure

0 - 400psi [0 - 30bar] in 50psi [5bar] increments

Thermoplastic Function

Automatically sets correct parameters for thermoplastic resins such as TransOptic? and cools the mount in a controlled, linear fashion

Compliance

In accordance with EC Directives