|
|
||||||||||||||||||||||||||||
進口高壓電磁閥
由中國深圳市派克閥門有限公司總代理,負責中國區的產品銷售及售后服務。
德國雷普LIP高壓電磁閥總代理深圳派克閥門有限公司
質量穩定:實行全過程質量管理,細致入微,實行各工件全面檢測!
合理:高效成本內部控制,提高生產效率,讓利于客戶!
交貨準時:先進生產流水線,充足的備貨,縮短了交貨期!
安裝維護Installation and maintenance:
1、現場安裝必須按照國家防爆危險場所“電氣安全規程”中有關規定進行。
2、電磁閥內外接地,必須牢固可靠。
3、電磁閥引出電纜導線為三根,其中一根為接地線,另二根為工作導線。
4、電磁閥安裝前應將管路內部清洗干凈。
5、電磁閥有雜質時,進口端前必須安裝密度0.5mm的過濾器。
6、安裝電磁閥時注意閥體上箭頭要求與介質流向一致。
7、電磁閥應垂直安裝,線圈在上。
8、電磁閥維修時應斷電后開蓋,非電器人員不得拆卸電磁閥電氣部件。
1, on-site installation must be carried out in accordance with the national explosion-proof hazardous location
"Electrical safety regulations" the relevant provisions.
2, the solenoid valve inside and outside the ground, must be solid and reliable.
3, the solenoid valve lead cable conductors for the three, which one is the ground wire, and the other two wires to
work.
4, the solenoid valve is mounted inside the front line should be cleaned.
5, when the solenoid valve with impurities, must be installed before the inlet end of 0.5mm density filter.
6, pay attention to the arrow on the valve body in line with the medium flow requirements to install the solenoid
valve.
7, the solenoid valve should be mounted vertically on the coil.
8, when the solenoid valve repair after opening the lid off, non-electrical personnel may not disassemble solenoid
valve electrical components.
介質溫度: -200~+350℃
介質粘度: 小于50CSt(大于時需定制)
防護性能: IP65
閥體材質: SS304、SS316
控制方式: 常開、常閉
電源電壓: DC12~127V AC24~380V
連接方式: 內螺紋、外螺紋、法蘭等。
泄 漏 量: 零
適用范圍
CNG設備、燃?xì)庠O(shè)備、液壓系統、實驗裝備、測試設備、礦山機械、
壓泵站、清洗設備、壓縮機、空分設備、高機器制造等自動化控制。
選型說明:分為常閉和常開二種;一般選用常閉型,通電打開,斷電關閉;
但在開啟時間很長關閉時很短時要選用常開型了。
功能選項代號
K 常開型:就是通電閥關,斷電閥開
B 常閉型:就是通電閥開,斷電閥閉
E 防爆型: 防爆等級:Ex dⅡCT4/T5
J 配節能模塊: 降低線圈溫升和功耗,延長線圈壽命
電氣參數
電源電壓: 220V 110VAC50/60Hz24V 12VDC
額定功率: 通徑≥10mm且≥250bar,DC24為60W
其余為25W
電壓公差 ±10%
電氣連接 普通型:標準接線盒; 防爆型:M16*1.5,1.5M導線
產地:德國
品牌:德國雷普LIP